Used 1976 Chevrolet C10
$10,000(-5.3%)price drop
| Sequence | Date | Price Change | Current Price |
|---|---|---|---|
| 1. | 3/12/2026 (a month ago) | $189,500 | |
| 2. | 4/16/2026 (9 hours ago) | -$10,000 (-5.3%) | $179,500 |
- Pickup Truck
- Condition
- Used
- Transmission
- 6-Speed
- Exterior Color
- Nardo Gray
- Interior Color
- Red
- VIN
- CCV146A1465290000
Engine
- Fuel Type:Gasoline
Message from the seller
1976 Chevrolet C10 Custom Squarebody Chevrolet Race / Pro-Touring / Show Truck $275K+ Build Robert Yates Racing Engine Bowler 6-Speed MRC Chassis with approximately 129 miles on the clock. This professionally built Chevrolet Squarebody custom performance truck represents an extensive ground-up build with over $275,000 invested. There is not a single nut & bolt on this truck that was not replaced during the build. Using top-tier components and engineered for serious performance, this truck combines modern race engineering with restomod squarebody styling. Finished in Nardo Gray on a custom red powder coated tube chassis by Moore Race Chassis in Kernersville, NC. The truck is powered by Legendary NASCAR engine builder Robert Yates RY525 LS3-based engine paired to a Bowler 6-speed manual transmission and a Tiger quick-change rear end, creating an extremely capable street / track machine. This is a no-expense-spared build that not only performs but is show-quality finished. Drivetrain: Robert Yates Racing RY525 LS3 Engine Dyno-tested 547 whp / 482 lb ft torque Key specs: Target AFR: 12.8–13.4 Rev limiter: 7300 RPM Requires 93 octane fuel minimum Mobil 1 15W-50 (10 qt capacity) Bowler 6-speed manual transmission Tiger quick-change rear axle Chassis / Suspension / Wheels: MRC Tube chassis Hydroshox suspension system allowing you to retain spring rate at any height NASCAR inspired rear suspension setup using Earnhardt Technologies components Fully adjustable & customizable rear suspension links Aluminum billet front spindles & upper control arms Wilwood performance disc brakes w/ 6 piston calipers Flaming River steering rack MRC Custom 3-piece billet aluminum wheels with ARP hardware Technology & Equipment: Holley Sniper Stealth throttle body EFI Holley Pro-Dash digital display Jones accessory drive system Push-button start Vintage Air climate control Interior: Custom one-off interior done by Renown Innerworx in Sarasota, FL. Full roll cage Bucket seats with plaid inserts SPARC billet steering wheel Alpine Sound System Exterior: Nardo Gray paintwork with show quality bodywork Shaved drip rails Billet Rides mirrors
This Used 1976 Chevrolet C10 is available for drivers in Fort Myers, Cape Coral, Naples, Lehigh Acres, Bonita Springs, North Fort Myers, Estero, Punta Gorda ...